1985–1995 GM Throttle Body Injection
TBI Wire Harness | TBI Wiring
EPA-approved TBI wiring harnesses for 1986–95 CK Chevy and GMC trucks. Custom-built to your length spec with full emissions, VSS, and diagnostic capability.
Start a Build1986–91 TBI Wire Harness
The wire harness above is for the application years 1986–91 pre 4L60E. Complete with the wiring for emissions and VSS. We also have a device that will allow you to delete the VSS circuit. The device replicates a signal to the computer; the computer still thinks it's receiving the correct pulse.
1992–95 TBI Wire Harness
1992–95 TBI wire harnesses can also be designed to the length you specify. In 1992 the 4L60E transmission was placed in the CK Chevy trucks. The main difference between the 4L60 and the 4L60E is the valve body.
What sets them apart is the (E), which stands for electronic valve body. With a SSW harness you have diagnostic capability (ALDL), spark control and all the correct power and ground connections required to run correctly.
Secure Online Purchasing
For special requests: Contact SSW
TBI 1985–1995 — 204 HP / 329 ft-lb Throttle Body Injection
CK Chevy and GMC truck. You will find a creation of fuel injection known as Throttle Body Injection. This injection system, in many opinions, is the most reliable and self-sustaining design ever. Lasting 10 years makes this the longest and most successful engine and fuel injection design ever to come from GM.
The variation of sizes range from 4.3, 5.0, 5.7 and 7.4 liter servings. Pick your poison of any, check your power to weight ratio and enjoy a reliable engine in any size from this genre. The timing of this unit is a large High Energy Ignition (HEI) distributor, with a top-mounted coil on the cap.
In 1992–95 a new distributor design moved the coil to an external side-mount location. The new distributor known as Energy Ignition (EI), dubbed "Small distributor," was introduced that allowed a cleaner throttle response.
The fuel metering is controlled by a basic Speed Density operation. Consisting of RPM from the distributor, Intake Air Temp (IAT) sensor to calculate the mass amount of air, and the Coolant Temperature Sensor (CTS). The system has the capability to meter the vacuum through the Manifold Absolute Pressure (MAP) sensor.
The MAP sensor will adjust timing and fuel depending on load conditions, based on internal vacuum pressures — adjusting accordingly based on altitude and work performed. The TBI engine 1986–91 was equipped with two transmission options: a 700R4 or 5-speed. In 1992, the 4L60E transmission became available, as well as the 4L80E for the ¾ and 1-ton truck.
Available Engine Sizes
- 4.3L
- 5.0L
- 5.7L
- 7.4L
Transmission Options
- 700R4
- 5-Speed
- 4L60E
- 4L80E
All EPA Approved Wire Harnesses Come With:
- VSS Circuit
- Diagnostic Link Connector
- Correct Connector for Emissions Components
- VSS Pigtail
- Alternator
- Tach Pigtail
Ready to Build Your TBI Harness?
Custom-built to your length spec. EPA approved. USA made since 1999.
Start a Build